Tools

General Purpose File Handle

Tools Information

The Hard Duck company would like to take as much frustration out of the job of venting as possible. One of those tasks is acquiring all that is needed. We will help you do just that in one stop shopping. Here on this page are all the Tools you might need for Installing

Products

General Purpose File Handle
General Purpose File Handle

Handle comes with adapters to fit all files.

General Purpose Half Round File
General Purpose Half Round File

This file is perfect for taking burrs off duct after cutting, It is best to have little Sharpe edges in a sealed system to protect gaskets. File and handle sold separately

Hole Saw
Hole Saw

4 1/2 inch hole saw for dryer venting with solid made construction to with stand the tough conditions typical with hole saws

Hole Saw Arbor
Hole Saw Arbor

This is the part you need to use the hole saw it threads into hole saw and then locks with a pin system  Pilot bit is made to remove for replacement

Snip Green
Snip Green

This is a quality aviation snip that makes cutting duct easy.Red and green snips are marked to show cut direction in most cases ether snip will get the job done..... in cutting duct in tight spots its good to have both.

Snip Offset
Snip Offset

This is a quality aviation snip that makes cutting duct easy. Red and green snips are marked to show cut direction in most cases ether snip will get the job done..... in cutting duct in tight spots its good to have both and a offset snip can lend a bit more diversity.

Snip Red
Snip Red

This is a quality aviation snip that makes cutting duct easy. Red and green snips are marked to show cut direction in most cases ether snip will get the job done. In cutting duct in tight spots its good to have both.